An owner wants to fly his engine after it sat for 7 years. Plus, prop strike at the shop, lean of peak, and break-in trouble. Email [email protected] for a chance to be on the show.

Join the world's largest aviation community at aopa.org/join

Full episode notes below:

Rupert is having trouble breaking in his new cylinders. They have five hours and the temperatures are still trying to go above 420 degrees on departure. They’ve checked fuel flow and baffling. In a twist of irony he is causing his cylinders to run too hot because the break-in is being prolonged because he won’t run the engine hard enough. Paul said Comanche’s have notoriously have poor baffling, which can also compound the problem. They recommend running it hard for a few hours and not to worry about the temps being around 420.

Craig has a Pitts that was damaged on a high-power run-up after his annual. The tail came up and hit the prop. He’s wondering if there’s something else they should inspect since the case is going to be open. His crank is subject to an AD. The associated service bulletin requires replacement if the case is opened, but the AD does not. He said the insurance has agreed to replace the crankshaft anyway. They said other than close cylinder inspections, it sounds like he’s fully covered.

Larry was finding that the lean of peak indication on his Dynon would show that he was lean of peak before the cylinders were actually there. He found a short paragraph in the manual that says if he changes the horsepower percent rating, it works fine. He also describes a procedure in the Dynon that basically recreates the GAMI lean test. Mike describes how Savvy does the AI engine modeling. The amount of air or fuel going into the engine will be the limiting power factor. In rich of peak, fuel is abundant, so air is the limiting factor. In lean of peak, fuel is the limiting factor.

Dave last ran his engine 7 years ago. He mixed oil and camgard, put it into a pressurized tank, and sprayed it under pressure into every place he could. He’s changed desiccant plugs, and had a dehumidifier running as well. If he has pitting he’s wondering if it’s dangerous to fly. Paul said airplanes don’t fall out of the sky because of pitting on the camshaft, and Mike added that they do fall out of the sky after taking off cylinders to look for signs of corrosion. Either the engine will make metal in the filter or it won’t, he said. If the filter is clean for the next 100 hours he dodged a bullet. Nothing that could be wrong corrosion wise is a safety of flight item. It’s a safety of wallet item. Paul said he would recommend changing the oil soon after running it. If the cylinders don’t look corroded the bottom end probably isn’t either, Mike said. Paul suggests he crank the engine with one set of plugs inoperative until he gets an oil pressure indication, and then start it normally.