I've been doing a lot of resawing lately in my workshop. Not for the purpose of making my own veneers instead it's all about milling thin stock for the boxes I'm making for my wife's photography clients (shameless plug...www.shuttersam.com. Resawing thick stock into thinner pieces is a great way to save materials and money too! As a beginning woodworker my assumption was that thin stock, anything thinner than 3/4", was a rare item and either you settled for the warped and over-priced stuff at the home center or you repeatedly ran the stock through a thickness planer until it was the dimension you desired. Then one day the light bulb went off (actually I read an article) and I discovered resawing. In today's episode, I'll share with you a few options I've experimented with when it comes to resawing. I've tried it on the tablesaw and I've had some success with a handsaw, but my preferred way is on the bandsaw. And even that has changed slightly over the past year. Regardless of which route you choose for whatever reason; limited tools, experience or self-loathing, learning to resaw can open a whole new set of options for you in the shop and with your projects.